Video Selfviewdefault Pipposition; Video Monitors; Video Osd Wallpaperselection; Video Osd Languageselection - Cisco EX60 Administrator's Manual

Cisco TelePresence System EX Series
Contents

Video SelfviewDefault PIPPosition

Determine the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video SelfviewDefault mode
setting) and fullscreen view is switched off (see the Video SelfviewDefault Fullscreenmode
setting).
Requires user role: ADmIn
Value space: <Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/LowerLeft/
LowerRight >
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
Video SelfviewDefault PIPPosition: Current
Example:

Video SelfviewDefault OnMonitorRole

Determine which monitor/output to display the main video source (self-view) on after a call. The
value reflects the monitor roles set for the different outputs in the Video output HDmI/Internal
monitorRole settings.
The setting applies both when self-view is displayed in full screen, and when it is displayed as
picture-in-picture (PiP), but only if the Video monitors setting is set to Dual.
Requires user role: ADmIn
Value space: <First/Second/Current>
First: The self-view picture will be shown on outputs with the Video output LCD/Internal
monitorRole set to First.
Second: The self-view picture will be shown on outputs with the Video output LCD/Internal
monitorRole set to Second.
Current: When leaving the call, the self-view picture will be kept on the same output as
during the call.
Video SelfviewDefault OnMonitorRole: Current
Example:
D14726.14 EX Series Administrator Guide TC7.1, APRIL 2014.
Introduction Web interface System settings System settings

Video Monitors

Set the monitor layout mode.
Requires user role: ADmIn
Value space: <Single/DualPresentationonly>
Single: The same layout is shown on all monitors.
DualPresentationOnly: All participants in the call will be shown on the first monitor, while the
presentation (if any) will be shown on the second monitor. This value is not supported on
EX60.
Video Monitors: Single
Example:
Video OSD Mode
This setting is not applicable for this product.

Video OSD WallpaperSelection

This setting is not applicable for this product.

Video OSD LanguageSelection

This setting is not applicable for this product.

Video OSD MenuStartupMode

This setting is not applicable for this product.

Video OSD VirtualKeyboard

This setting is not applicable for this product.
www.cisco.com — Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
106
Administrator Guide
Setting passwords Appendices