Video Settings - Cisco EX60 Administrator's Manual

Cisco TelePresence System EX Series
Contents

Video settings

Video AllowWebSnapshots
Allow or disallow snapshots being taken of the local input sources, remote sites and
presentation channel. If allowed, the web interface Call Control page will show snapshots both
when idle and in a call.
noTE: This feature is disabled by default, and must be enabled from the Touch controller.
Requires user role: ADmIn
Value space: <off/on>
Off: Capturing web snapshots is not allowed.
On: Web snapshots can be captured and displayed on the web interface.
Video AllowWebSnapshots: Off
Example:
Video CamCtrlPip CallSetup Mode
This setting is used to switch on self-view for a short while when setting up a call. The Video
CamCtrlPip CallSetup Duration setting determines for how long it remains on. This applies when
self-view in general is switched off.
Requires user role: ADmIn
Value space: <off/on>
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.
Video CamCtrlPip CallSetup Mode: Off
Example:
Video CamCtrlPip CallSetup Duration
This setting only has an effect when the Video CamCtrlPip CallSetup mode setting is switched
on. In this case, the number of seconds set here determines for how long self-view is shown
before it is automatically switched off.
Requires user role: ADmIn
Value space: <1..60>
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
Video CamCtrlPip CallSetup Duration: 10
Example:
D14726.14 EX Series Administrator Guide TC7.1, APRIL 2014.
Introduction Web interface System settings System settings
Video ControlPanel Brightness
Set the brightness level for the Touch controller.
Requires user role: ADmIn
Value space: <0..100>
Range: Select a value from 0 to 100.
Video ControlPanel Brightness: 100
Example:
Video DefaultPresentationSource
not applicable for products using a Touch controller.
Video Input DVI [2]/[1] RGBQuantizationRange
noTE: EX90 has the DVI 2 input connector and EX60 has the DVI 1 input connector.
All devices with DVI inputs should follow the rules for RGB video quantization range defined in
CEA-861. Unfortunately some devices do not follow the standard and this configuration may be
used to override the settings to get a perfect image with any source. The default value is set to
Full because most DVI sources expects full quantization range.
Requires user role: ADmIn
Value space: <Auto/Full/Limited>
Auto: RGB quantization range is automatically selected based on video format according to
CEA-861-E. CE video formats will use limited quantization range levels. IT video formats will
use full quantization range levels.
Full: Full quantization range. The R, G, B quantization range includes all code values (0 -
255). This is defined in CEA-861-E.
Limited: Limited Quantization Range. R, G, B quantization range that excludes some code
values at the extremes (16 - 235). This is defined in CEA-861-E.
Video Input 1 DVI 2 RGBQuantizationRange: Full
Example:
www.cisco.com — Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
99
Administrator Guide
Setting passwords Appendices