Cisco EX60 Administrator's Manual page 64

Cisco TelePresence System EX Series
Contents
Conference [1..1] Encryption Mode
Set the conference encryption mode. A padlock with the text "Encryption on" or "Encryption
off" displays on screen for a few seconds when the conference starts.
noTE: Requires the Encryption option Key to be installed. When the Encryption option Key is
not installed the encryption mode is set to off.
Requires user role: ADmIn
Value space: <off/on/BestEffort>
Off: The system will not use encryption.
On: The system will only allow calls that are encrypted.
BestEffort: The system will use encryption whenever possible.
> In Point to point calls: If the far end system supports encryption (AES-128), the call will be
encrypted. If not, the call will proceed without encryption.
> In MultiSite calls: In order to have encrypted multiSite conferences, all sites must support
encryption. If not, the conference will be unencrypted.
Conference 1 Encryption Mode: BestEffort
Example:
Conference [1..1] DefaultCall Protocol
Set the Default Call Protocol to be used when placing calls from the system.
Requires user role: ADmIn
Value space: <Auto/H323/Sip/H320>
Auto: Enables auto-selection of the call protocol based on which protocols are available.
If multiple protocols are available, the order of priority is: 1) SIP; 2) H323; 3) H320. If the
system cannot register, or the call protocol is not enabled, the auto-selection chooses H323.
H323: H323 ensures that calls are set up as H.323 calls.
Sip: Sip ensures that calls are set up as SIP calls.
H320: H320 ensures that calls are set up as H.320 calls (only applicable if connected to a
Cisco TelePresence ISDn Link gateway).
Conference 1 DefaultCall Protocol: H323
Example:
D14726.14 EX Series Administrator Guide TC7.1, APRIL 2014.
Introduction Web interface System settings System settings
Conference [1..1] DefaultCall Rate
Set the Default Call Rate to be used when placing calls from the system.
Requires user role: ADmIn
Value space: <64..6000>
Range: Select a value between 64 and 6000 kbps.
Conference 1 DefaultCall Rate: 1920
Example:
Conference [1..1] MaxTransmitCallRate
Specify the maximum transmit bit rate to be used when placing or receiving calls. note that this
is the maximum bit rate for each individual call; use the Conference maxTotalTransmitCallRate
setting to set the aggregated maximum for all simultaneous active calls.
Requires user role: ADmIn
Value space: <64..6000>
Range: Select a value between 64 and 6000 kbps.
Conference 1 MaxTransmitCallRate: 6000
Example:
Conference [1..1] MaxReceiveCallRate
Specify the maximum receive bit rate to be used when placing or receiving calls. note that this
is the maximum bit rate for each individual call; use the Conference maxTotalReceiveCallRate
setting to set the aggregated maximum for all simultaneous active calls.
Requires user role: ADmIn
Value space: <64..6000>
Range: Select a value between 64 and 6000 kbps.
Conference 1 MaxReceiveCallRate: 6000
Example:
www.cisco.com — Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
64
Administrator Guide
Setting passwords Appendices