Changing Fuel Screen/Engine Oil Level; Service Work On The Engine; Changing The Fuel Screen; Checking The Engine Oil Level - Husqvarna 2014 FC 250 EU Owner's Manual

17

SERVICE WORK ON THE ENGINE

17.1

Changing the fuel screen

Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel
is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with the
eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with soap and
water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
17.2

Checking the engine oil level

Info
The engine oil level can be checked when the engine is cold or warm.
x
–
Clean the plug-in connection
Info
Under no circumstances should dirt enter into the fuel line. Dirt clogs the
injection valve.
–
Disconnect the plug-in connection of the fuel line.
–
Pull fuel screen
–
Insert the new fuel screen all the way into the connecting piece.
–
Lubricate the O-ring and connect the plug-in connection of the fuel line.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
–
–
Start the engine and check the response.
B01911-10
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Condition
The engine is cold.
–
Check the engine oil level.
The engine oil level is up to the middle
» If the engine oil is not up to the middle of the level viewer:
–
Condition
The engine is at operating temperature.
B01776-11
–
Check the engine oil level.
1 of the fuel line thoroughly with compressed air.
2
out of the connecting piece.
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effec-
tive exhaust extraction system.
Add engine oil. ( p. 79)
Info
After switching off the engine, wait one minute before checking the level.
A
of the level viewer.
76