Husqvarna 2014 FC 250 EU Owner's Manual page 80

17 SERVICE WORK ON THE ENGINE
–
Remove screws
B01915-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
B01916-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with engine
oil.
–
Fill the oil filter with engine oil and place it in the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
B01915-11
–
Remove the oil filler plug
engine oil.
Engine oil
B01917-10
Info
Too little engine oil or poor-quality engine oil results in premature wear to the
engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
5 . Remove the oil filter cover with the O-ring.
6
out of the oil filter housing.
8
with the O-ring from the clutch cover and fill up with
1.10 l (1.16 qt.)
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effec-
tive exhaust extraction system.
p. 76)
7
M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil (SAE
oil for harsh oper- 10W/60) (
ating conditions
and increased per-
formance
78
.
p. 91)
p. 91)