Installing The Fork Legs - Husqvarna 2014 FC 250 EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.8

Installing the fork legs

Main work
–
Remove screws
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
Info
Do not pull the hand brake lever when the front wheel is removed.
B00300-10
–
Loosen screws
–
Unscrew screws
B01850-10
x
Main work
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the upper
triple clamp.
B01848-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B01850-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Position the brake line and clamp. Mount and tighten screws
B00300-11
Finishing work
–
Install the front wheel.
1
and take off the clamp.
2
and take off the brake caliper.
3
. Take out the left fork leg.
4
. Take out the right fork leg.
1
face forward.
2
.
3 .
M8
( p. 64)
x
M8 17 Nm (12.5 lbf ft)
M8 12 Nm (8.9 lbf ft)
5
.
Loctite
25 Nm
(18.4 lbf ft)
4
.
34
243™
®