Network Configuration; Ethernet Setup - Westpac EFTPOS 1 User Manual

8

Network Configuration

8�1

Ethernet Setup

Your terminal has the ability to process transactions through a broadband connection. If you
wish to use your broadband connection for transaction processing (via an Ethernet cable)
please connect your terminal base to your broadband modem and follow the steps below.
Note: Most networks use Dynamic Host Configuration Protocol "DHCP" to allocate unique
addresses to each computer on your network. It is recommended that you have DHCP Turned
on at your router.
If DHCP is not turned on, you will need to have the following information on hand prior to
your new terminal being installed:
• IP Address
• Subnet Mask
• Default Gateway
• Primary DNS
• Secondary DNS
Step Terminal Display
1
Utility
1. Reset Terminal
2. Delete S&F
3. Network
4. Bluetooth Config
54
Action
On the main menu navigate to and select the
"Utility" option on the touch screen or enter the
number of the menu item using the keypad.
In the Utility menu select the "Network" option on
the touch screen or enter the number of the menu
item using the keypad.
EFTPOS 1 USER GUIDE
Step Terminal Display Action
2 Select the" 3. Ethernet" option on the touch
Network
screen or enter the number of the menu item using
Select Type
the keypad.
1. WIFI
2. GPRS
3. Ethernet
3 Select "2. Enable" option on the touch screen
Ethernet
or enter the number of the menu item using the
keypad.
Network
1. Edit
2. Disable
4 The terminal will now attempt to connect.
Once successful the terminal will then revert back
to the idle screen.
Connecting
Ethernet
Please wait
EFTPOS 1 USER GUIDE 55