Accessories; Options/Accessories - Lincoln Electric CLASSICII SVM125-A Service Manual

C-2

OPTIONS/ACCESSORIES

The following options/accessories are available for
your Classic II from your local Lincoln Distributor.
Undercarriage - Under 10 MPH (K768) - For in-plant
or yard towing of the Classic II. Not intended for high-
way towing.
Undercarriage (K913-1) - Two-wheeled undercarriage
for in-plant and yard towing. Includes fender and light
kit; three optional hitch choices. For highway use, con-
sult applicable federal, state, and local laws.
Power Plug Kit (K802-C) - Provides four 20 amp, 115
volt plugs and one 50 amp, dual voltage (115/230V),
full kVA plug. NOTE: For CSA machines and machines
with GFCI receptacles, use Power Plug Kit K802-R.)
Power Plug Kit (K802-D) - Provides four 15 amp, 115
volt plugs and one 50 amp, dual voltage (115/230V),
full kVA plug. (For non-CSA machines.)
CV Adapter - Below Code 10050 - (K384) - Provides
constant voltage output for semiautomatic welding.
Ether Start Kit (K887-1) - Automatic ether start kit pro-
vides cold weather starting assistance in temperatures
below 10 o F (-12.2 o C). Requires an ether tank that must
be purchased locally.
NOTE: Ether starting can contribute to shortened
engine life. Avoid unnecessary or indiscriminate use.
Linc Thaw™ Control Unit (L2964-5) - Includes meter
and fuses to protect the welder when thawing frozen
water pipes.
WARNING
PIPE THAWING can result in fire, explosion, damage
to pipes, wiring, and the welder as well as other unsafe
or hazardous conditions. Do not use a welder to thaw
pipes before reviewing Lincoln Bulletin E695.1 (dated
October 1987 or later).

ACCESSORIES

Wire Feed Module - Above Code 10050 (K623-1) -
Provides constant voltage output for semiautomatic
welding. Includes remote for CV mode and internal
"Cold Tip Contactor" for the LN-7 and LN-23P.
Accessory Kit (K703) - Includes the following:
• Thirty-five feet (10.5 meters) of #2 AWG electrode
cable
• Thirty feet (9.1 meters) of #2 AWG work cable
• Headshield with No. 12 filter.
• GC300 work clamp
• Cooltong™ 300 insulated electrode holder
The cables are rated at 250 amps, 40% duty cycle.
Spark Arrester Kit (K899-1) - A field-installed kit for
the Classic II diesel engine muffler exhaust pipe.
Includes a heavy-gauge steel, approved spark arrester,
mounting clamp and adapter.
Remote Control - 100 Feet, Below Code 10050 -
(K888-2) - Includes a control box with 100 ft. (7.5
meters) of 4-conductor cable. Allows output to be con-
trolled remotely.
Remote Control Kit - Above Code 10050 - (K924-1)
- Includes a control box with 100 ft. (7.5 meters) of 4-
conductor cable.
remotely.
GFCI Receptacle Kit (K896-2) - Includes a UL
approved 115 volt ground fault circuit interrupter recep-
tacle (duplex type) with covers and installation instruc-
tions. Each half of the receptacle is rated 15 amps, but
the maximum total current from the GFCI duplex is lim-
ited to 20 amps. The GFCI receptacle replaces the
factory installed 115 volt duplex receptacle.
CLASSIC II
Allows output to be controlled
C-2