Troubleshoot - Primex XR PERSONAL SERIES Installation & User Manual

T
ROUBLESHOOT
To identify and solve problems with the Personal Series Clock refer to the table below.
Table 3: Troubleshooting the Personal Series Clock
Symptom
The display is "locked up" (time is
visible but is not updating).
The display shows dashes.
The clock does not beep after pressing
the button to verify network
connectivity.
The low battery indicator is visible.
The signal indicator is flashing
Primex Wireless
Explanation
New batteries were installed without allowing
power to drain from the clock.
The clock is powering up and a signal has not been
received.
The clock is not receiving a signal from the Primex
Wireless Transmitter or the batteries are defective.
The batteries are low.
The clock has not decoded a signal from the trans-
mitter for four days.
XR Personal Series LCD Clock Installation & User Guide
Corrective Actions
Remove the batteries. Wait 10 seconds before
replacing the batteries.
Place the clock in a different location.
Check that the Primex Wireless Transmitter
was broadcasting during the clock
initialization.
Test the clock in a different location.
Check the Primex Wireless Transmitter.
Replace the batteries.
Replace batteries.
Check the Primex Wireless Transmitter.
15