Replacing The Boards - Samsung OfficeServ 7030 Installation Manual

2.3 Replacing the Boards

If the OfficeServ 7030 system fails to operate normally due to an error on the power supply
board, base board or daughter board, replace the board with a new one.
To replace a board mounted in the slot of a cabinet, proceed as follows:
1) Turn off the power of the cabinet in which the board is mounted.
© SAMSUNG Electronics Co., Ltd.
Removing the Cables
Before replacing a daughter board, remove all cables connected to the board.
Figure 2.20 Turning Off the Cabinet Power
OfficeServ 7030 Installation Manual
15