Connect Cables - Cisco TelePresence MX800 Single Installation Manual

Installation guide for Cisco TelePresence MX800 Single - Wall mount
8

Connect cables

B, E
Remove protection foam
from cameras. Make sure
that cameras can move freely
before connecting power.
Always use the power cables
provided.
The plug-socket combination
must always be accessible,
because it serves as the main
disconnecting device.
Power (100-240 VAC, 50/60 Hz),
extension cord, and country-specific cable
78-100255-02A0 | AUGUST 2015 | © 2015 Cisco Systems, Inc. All rights reserved.
(page 1 of 2)
Microphones
(max 8)
Network
1
Codec connector panel
Video input
(for example
computer)
2
Route the cables along
the lower frame, and place
them in the cable bridge.
CAT 5e, shielded Ethernet cable, 5 m.
1
Two presentation cables are provided: HDMI ↔ HDMI;
2
and DVI/Euroblock ↔ VGA/mini jack.
Page 12