Cisco TelePresence MX800 Single Installation Manual page 5

Installation guide for Cisco TelePresence MX800 Single - Wall mount
2
Mount wall bracket
G
The lower edge of the
screen image will be
at the height of these
horizontal slots.
We recommend that
the distance from
the floor to this line is
70 cm / 27.6 in.
*
Check that the wall bracket is level and mark the required
screw hole positions on the wall. Use at least four screws
when fastening the wall bracket. The wall bracket can be
fastened through any of the horizontal slots.
Fasten the wall bracket in a secure manner ensuring that the
wall's structure is sufficient to support the system load (screws
and mounting hardware not provided; not shown in illustration).
78-100255-02A0 | AUGUST 2015 | © 2015 Cisco Systems, Inc. All rights reserved.
* If you mount the system higher, note the following consequences:
- You may need to increase the distance between the video system and the
table in order for the camera to capture the closest participants.
- The camera will give an elevated view of the room. This view is not optimal
for video conferencing.
Further information: http://www.cisco.com/go/projectworkplace
2D CAD drawings with measurements:
http://www.cisco.com/go/mx-docs (Technical References)
Page 5