Start Up The System - Cisco TelePresence MX800 Single Installation Manual

Installation guide for Cisco TelePresence MX800 Single - Wall mount
9

Start up the system

• Remove the protection foil from the display.
• Make sure that cameras can move freely.
• Insert the network and power cables into the wall outlets.
• Switch on the system.
The power switch is located directly below the codec, next to
the power connector.
Wait a few minutes while the system starts up. The start-up
may include automatic software upgrade and restart of
Touch 10 and cameras.
• Follow the instructions on Touch 10.
If your system is not set up to be automatically provisioned,
configure the system before you make your first call. Initial
configuration is described in the Getting Started Guide on the
Cisco website.
78-100255-02A0 | AUGUST 2015 | © 2015 Cisco Systems, Inc. All rights reserved. Page 14