Husqvarna 250 PS Workshop Manual page 13

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
Thread in a new cord and attach it to the pulley.
Wind about 4 turns of the cord around the pulley,
anticlockwise. Fit the pulley above the spring cassette so
that the end of the return spring engages in the pulley.
Fit the bolt through the centre of the pulley.
Thread the starter cord through the hole in the starter
casing, then through the starter handle. Tie a good knot
in the end of the cord.
Run the cord through the cut-out in the pulley and wind
the spring up a couple of turns. Make sure the pulley is
free to rotate a further 1 1/2 turns when the cord is fully
extended.
Refit the starter unit by first pulling out the starter cord
and then placing the starter unit in position on the
crankcase. Now release the starter cord slowly so that
the starter lugs engage on the pulley. (Starter lugs, see
page 26.) Tighten the bolts that hold the starter unit.
Refit the cylinder cover and tank.
2
13