Husqvarna 250 PS Workshop Manual page 27

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
5
Connect the short circuit lead to the ignition module and
fit the module on the crankcase without tightening the
screws. Place the feeler gauge between the module and
the flywheel magnets. Push the module against the
flywheel and tighten the screws.
Fit the air baffle. Make sure the leads are routed
correctly and cannot become trapped. Fit the starter unit.
Fitting the spark plug cap
Make a hole in the ignition lead using pliers
502 50 06-01.
Push the ignition lead through the spark plug cap and fit
the connector spring using the tongs. Slide the cap back
over the connector spring.
27
www.mymowerparts.com