Throttle Lock - Husqvarna 250 PS Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

4. Throttle lock

Removal
Undo the six screws that hold the handle together.
Open up the handle. Remove the throttle lock and check
the spring underneath it.
Assembly
Secure the spring under the throttle lock and lay the
cable and leads as shown in the diagram. Assemble the
two halves of the handle and tighten the 6 screws.
Replacing the throttle cable
Take the handle apart and disconnect the throttle cable.
Disconnect the throttle cable from the carburettor and
pull it out through the sleeve.
Thread a new cable through the sleeve, connect it to the
carburettor and the handle. Refit the throttle lock and
spring. Reassemble the halves of the handle and tighten
the screws.
24
www.mymowerparts.com