About Your Projector; Remote Control - Panasonic PT-DX820 Operating Instructions Manual

About your projector

Remote control

1 Power standby <v> button
Sets the projector to the state where the projector is switched
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
2 Power on <b> button
Starts projection when the <MAIN POWER> switch on the
projector is set to <ON> when the power is switched off
(standby mode).
3 Remote control indicator
Blinks if any button in the remote control is pressed.
4 Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons
Adjusts the projection lens. (x page 62)
5 <MENU> button/<ENTER> button/asqw buttons
Used to navigate through the menu screen. (x page 71)
6 <ON SCREEN> button
Switches the on-screen display function on (display) or off
(hide). (x page 66)
7 Input selection (<RGB1/2>, <DIGITAL LINK>, <DVI-D>,
<VIDEO>, <SDI>, <HDMI>) buttons
Switches the input signal to project. (x page 67)
(SDI input is supported only for PT-DZ780.)
8 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(x page 68)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
Note
f When operating the remote control by directly pointing at the remote control signal receiver of the projector body, operate the remote
control within a distance approx. 30 m (98'5") from the remote control signal receiver. The remote control can control at angles of up to ±30°
vertically and horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
24 - ENGLISH
Chapter 1 Preparation — About your projector
Front
1
2
3
4
5
11
6
12
7
13
8
14
9
15
10
Top
Bottom
17
9 Number (<0> - <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
10 <AUTO SETUP> button
Automatically adjusts the image display position while projecting
the image.
[PROGRESS] is displayed while in automatic adjustment.
(x page 68)
11 <SHUTTER> button
Used to temporarily turn off the image. (x page 66)
12 <TEST PATTERN> button
Displays the test pattern. (x page 68)
13 <STATUS> button
Displays the projector information.
14 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 72)
15 <ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 28)
16 Remote control signal transmitter
17 Remote control wired terminal
This is the terminal used to connect to the projector via a cable
when used as a wired remote control. (x page 29)
16