Panasonic PT-DX820 Operating Instructions Manual page 58

Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (installation setting)
Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to
"Installation mode" (x page 31) for details.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP]
menu.
1) Press as to select an item.
2) Press qw to switch the setting.
3) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this function to [ECO]. After
completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [STANDBY
MODE].
1) Press qw to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. If [ALL USER DATA] is
executed from the [PROJECTOR SETUP] menu → [INITIALIZE], the setting of [STANDBY MODE] set before execution is displayed.
58 - ENGLISH
INITIAL SETTING
PROJECTION METHOD FRONT/FLOOR
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
COOLING CONDITION AUTO
It may shorten the life of the lamp and projector if used
in incorrect setting.
MENU SELECT CHANGE
SET
ENTER
INITIAL SETTING
STANDBY MODE NORMAL
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
CHANGE
SET
ENTER
2/6
3/6