Panasonic PT-DX820 Operating Instructions Manual page 148

r [WARNING] items
Item
[AC POWER]
[LOW-TEMPERATURE]
[HORIZONTAL TILT]
[LIGHT OUTPUT LIMIT]
[INTAKE AIR TEMPERATURE]
[OPTICS MODULE TEMPERATURE]
[EXHAUST AIR TEMPERATURE]
[LAMP1 REMAIN TIME]
[LAMP2 REMAIN TIME]
[BATTERY]
[AIR FILTER CASE]
[AIR FILTER]
[Network status] page
Click [Status] → [Network status].
The current network setting status is displayed.
148 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
AC input voltage is weak. Use electric wiring that can sufficiently withstand the power
consumption of the projector.
The temperature around the optics module inside the projector is low. Projection cannot
be started until the optics module becomes warm.
The projector is used tilted at an angle that exceeds 15° from the horizontal plane.
The projector may be used in an environment where the temperature is high. The light
output is reduced by approx. 20 % to protect the projector.
The intake air temperature is high. The projector may be used in an environment where
the temperature is high, such as near a heating appliance.
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
The exhaust air temperature is high. The air exhaust port may be blocked.
The runtime of the lamp has exceeded the specified time, and it is time to replace the
lamp.
Battery replacement is required. Consult your dealer.
The air filter case is not attached. Check the attachment of the air filter unit.
(x page 165)
There is too much dust accumulated in the air filter. Turn the <MAIN POWER> switch
<OFF> (x page 61), and clean the air filter. (x page 165)
Description