Copying Data From P2 Cards To The Hard Drive (Usb Host Mode); Switching To The Usb Host Mode; Usable Hard Drives - Panasonic AG-HPG10P Operating Instructions Manual

Copying data from P2 cards to the hard drive (USB HOST mode)

Switching to the USB HOST mode

1
Hold down [POWER] for at least 2 seconds
to turn the power on.
The thumbnail screen now appears.
2
Press [THUMBNAIL/MODE] to display the
thumbnail display off screen.
3
Press [MENU/MODE CHK].
4
Using , and , select "OTHER
FUNCTIONS" – "PC MODE", and press
5
Using and , select "USB HOST", and
press .
6
Press [MENU/MODE CHK] twice to display
the thumbnail display off screen.

Usable hard drives

The following hard drive can be used.
• Panasonic portable hard disk unit for P2 store (AJ-PCS060G)
• Any hard drive which can be connected using USB 2.0
• USB bus power (5 V, 0.5 A) is also supported, but some hard drives cannot be started up using it. If this
is the case, supply power from a separate source to the hard drive.
• Some hard drives may not operate properly.
• Do not use USB memories or other removable media.
7
Hold down [THUMBNAIL/MODE] for at least
2 seconds.
The USB HOST mode is now established,
and "USB HOST" appears at the bottom of the
thumbnail screen.
.
• Use a hard drive with enough memory to
accommodate the data to be copied.
• Clips on the hard drive cannot be played back.
• In the USB HOST mode, 1394 input signals
cannot be recorded.
• In the USB HOST mode, no sound will be
output from any of the connectors except for the
headphone jack.
To exit the HOST mode
1
Hold down [POWER] for at least 2 seconds
to turn off the unit's power.
The PC mode cannot be released simply by
holding down [THUMBNAIL/MODE].
55