Panasonic AG-HPG10P Operating Instructions Manual page 77

RECORDING SETUP screen (continued)
Item
UB MODE
UB PRESET
1394 IN PRESET
This is used to set what is to be recorded as the user's bit. "OFF" must be selected for
the "1394 UB REGEN" item setting. (Page 53)
USER:
The user information is recorded.
TIME:
The time of the recording is recorded.
DATE:
The date/time of the recording are recorded.
TCG:
The value generated by the time code generator is recorded.
FRM. RATE:
The information of the frame rate after frame conversion is recorded.
a b c
a: Information on the verification of the user's bit value
b: Frame sequence number
•"F" is displayed in the 60i/30P mode.
c: Frame rate information
• Frame rate (60, 30 or 24)
• I/P identification information
• Conversion information
• Frame rate factor
d: Recording control information
• Updated frame information
• REC START/STOP information
<Note>
When playing back native recorded clips
To set the 1394 output user's bit as the frame rate information, select FRM. RATE for
this setting, and play back the clips. If this is the case, the user's bit displayed on the
screen will also be changed to the frame rate information.
This is used to set the user's bit. "OFF" must be selected for the "1394 UB REGEN"
item setting and "USER" must be selected for the "UB MODE" item setting. (Page 53)
When [RESET/TC SET] is pressed, the value generated by the internal time code
generator is synchronized with the 1394 input time code. "OFF" must be selected for
the "1394 TC REGEN" item setting. (Page 52)
ON:
The 1394 input synchronization setting mode is established.
OFF:
The 1394 input synchronization setting mode is released.
Description of settings
d
The underlined settings are the factory mode settings.
77