Table of Contents
Advertisement
CONFIGURING SETTINGS FOR THE BENEFON TRACK PRO
Area tracking
When the area tracking is turned on, the position in-
formation will be sent to the service center only when
the phone is moving in or out of the pre-defined area.
The area can be determined by keying in a center
point and a radius of an area. The area tracking does
not contain duration option, i.e. the area tracking will
never be turned off automatically.
I N T E R V A L
The given interval, e.g. 60 minutes, indicates that the
phone will send its position to the service center at in-
tervals of 60 minutes, but only in case the phone is lo-
cated outside of the determined area.
Key in the interval for area tracking in minutes (3a).
C E N T E R P O I N T
Key in the center point name (e.g. Home) and enter
coordinates (3b).
R A D I U S
Key in the desired radius in 10 meters (3c). E.g. by
entering 20, your actual radius will be 200 meters.
26 TELEMATICS: SURVEILLANCE
A L A R M M O D E
You can set an alarm to alert when crossing the bor-
derline of an area. The alarm can be set to alert either
when arriving in or departing from the particular area
(3d).
Click the arrow and highlight the desired option.
A C T I V A T I O N
Make sure all the required settings for area tracking
are completed before activating the function. Such
settings are, e.g. center point, radius, alarm mode
and interval. New settings can be applied only while
the area tracking is deactivated.
In some phone models, e.g. in Track, area tracking
can be activated or deactivated from the phone menu.
In this case activation is completed only after the ser-
vice center sends an acknowledgement message to
the phone.
In some phone models area tracking activation or de-
activation cannot be initiated from the phone menu at
all. In this case area tracking is activated or deactivat-
ed by sending an MPTP message to the phone from the
service center.
Advertisement
Table of Contents
