S O S A C T I V A T I O; E M E R G E N C Y C A N C E L T I M; Making Emergency Cycle - Benefon Track Pro Configuration Manual

Table of Contents

Advertisement

CONFIGURING SETTINGS FOR THE BENEFON TRACK PRO

Making emergency cycle

Emergency cycle means making specific emergency
call to emergency center numbers. During the emer-
gency cycle emergency environment settings (e.g.
tone and display settings) are automatically switched
on until the cycle is over. For more information, see
CONFIGURING EMERGENCY ENVIRONMENTS ON PAGE 43
Depending on configuration, the emergency call can
contain both (voice) calls and messages. Calls can be
made to mobile phone numbers, or normal phone
numbers. Messages are protocol messages sent to
mobile phones via SMS. The emergency message con-
tains both GPS coordinates and GSM network mea-
surement report.
The emergency numbers are in priority order, starting
from the top of the list. These numbers work automat-
ically, as "a chain", through the list. If the first num-
ber is unreachable (after two attempts), the phone
calls or sends the report to the second number. If it is
not answered either, the phone will go on to the third
number on the list and so on.
The phone tries to reach contact with the other num-
bers once before moving on to the next number on
the list. If there is still no answer after going through
the whole list, the calling procedure will be started all
over. The phone will make three call rounds at maxi-
mum.
40 TELEMATICS: EMERGENCY SETTINGS
Emergency cycle is started by pressing the BeneGuard
<
button
button must be pressed the way it has been config-
ured: A long press or two quick presses. For more in-
formation, see
The emergency cycle is over when the calls are made
and messages are sent (if the cycle is not interrupted,
.
or cancelled), and the phone returns to normal oper-
ation.
In order to be able to cancel the emergency cycle, the
cancel time must be configured in the phone. For
more information, see
C
IRCUMSTANCES WHICH MAY AFFECT ON EMERGENCY CYCLE
1. Being in a shadow area of the GSM network at the
time of the event.
2. Poor GPS coverage during emergency cycle may
cause the emergency cycle completion to slow
down.
3. Busy telephone line - applies to a voice call con-
nection.
4. Message transmission error caused by the carrier
of an SMS, i.e. the network operator.
, located on the top of the phone. The
SOS ACTIVATION ON PAGE 38
EMERGENCY CANCEL TIME ON PAGE 38
.
.

Advertisement

Table of Contents
loading

Table of Contents