Table of Contents
Advertisement
Installing the Camera
Connecting the Cables
20
Figure 1-6
Pendant Dome Housing Installation
1.5" NPT threaded nipple
a.
Insert the field wiring (data, power, video, and alarm) from the mount through
the threaded nipple on the pendant housing.
b.
Carefully thread the housing into the mount.
5.
See
Power Cable Connection
wiring to the terminal strips on the interface board in the housing.
6.
See
Installing the Camera Assembly
camera assembly and
installing the lower dome.
1.
Follow
Figure 1-7
for the wiring connection.
Figure 1-7
Wiring
Coaxial Cables
Video: female BNC
Power
red +
black -
connect to red +
connect to ground
2.
Connect the power/video cable from the gimbal assembly to the camera board (see
Figure
1-8).
Route field wiring
from mount
on page
21
for information on connecting the field
on page
21
for information on installing the
Installing the Lower Dome
UTP Cables
Video: Unshielded
Twisted Pair wire
on page
23
for information on
Power: 2.1 mm
male jack center
Advertisement
Table of Contents
