Avaya 3600 Series Installation Instructions Manual page 37

3.5.2.2 3641/3645 Registration
Use the following process to register 3641 and 3645 phones:
1. Set the phone into administration mode:
a. With the phone powered off, while pressing the START key press and release the END key.
b. When the administration menu appears release the START key.
c. If the phone's administration password has been enabled, the phone will require that password to be entered
before it displays the administration menu. The default password is 123456. This step is not required if the
administration password has not been enabled.
2. Select Network Config.
The default mode for IP address operation is DHCP. The following is only required if the phone needs to be
switched to static IP address operation:
a. Select IP Addresses and then Static IP.
b. Set the IP Address, TFTP Server IP, Default Gateway and Subnet Mask information as required.
c. Set the Call Server IP to the LAN address of the IP Office.
d. Set the Call Server Port to 1719.
e. If installing with an AVPP for QoS control, set the AVPP IP address.
3. Select SSID.
Enter the SSID of the wireless network that the phone should use.
4. Select WLAN Settings.
· For installations using an AVPP:
a. Select Custom and then Security. Enter the security settings that match those configured for the access
points..
b. Select QoS and then SVP. Check that the QoS settings match those set for the AVPP. The defaults used
by the AVPP are 46 for WT in call and WT standby, 0 for Other.
· For installations using WMM:
a. Select Custom and then Security. Enter the security settings that match those configured for the access
points.
b. Select QoS and then Wi-Fi Standard. Check that the QoS settings match those set for the access points.
The defaults are 46 for Voice and Control, 0 for Other.
· For installations using CCXv4:
a. Select CCX. Select WPA2-Enterprise. Enter the security settings that match those configured for the
access points.
b. Select QoS. Check that the QoS settings match those set for the access points. The defaults are 46 for
Voice and Control, 0 for Other.
5. Select Reg Domain.
The regulatory domain must be set before the wireless frequency and transmit power can be selected. Press LINE
and then select the appropriate regulatory domain. 01 = North America. 02 = Europe.
a. Once the regulatory domain has been set, the wireless mode can be selected (802.11a, 802.11b or
802.11b/g). The modes available may vary according to the regulatory domain. If 802.11a is selected, the
frequency band or bands to use can also be selected.
b. Once the wireless mode is selected, depending on that selection and the regulatory domain, the Transmit
Power can be selected.
6. Select Phone Config.
7. Select Telephony Protocol.
The phones needs to be configured with a telephony protocol number which then ensures the handset checks for
the proper software files each time it powers on. Set the value to 033.
a. To change the displayed number, press Select.
b. To scroll through the options, press Up or Down.
c. To select the displayed number, press Select.
d. Select IP Office and set this to Enable.
8. Power cycle the phone.
a. If the phones software needs to be updated the new software will now be downloaded from the TFTP server.
The status bar will increment fully across the display for each function that is being performed in the download
process.
3600 Series Phone Installation
IP Office
Installation: Phone Installation
15-601082 Issue 06a (21 February 2014)
Page 37