Installation - Procom PCR60M Manual

INSTALLATION

This heater use a 1lb. propane cylinder. The heater is made to fasten to the wall.
WARNING: When this heater is not in use, the gas supply must be turned off. Propane gas cylinder must be
disconnected when a disposable cylinder is used.
WARNING:Only disposable cylinder marked with the proper fuel type approved for the appliance. It is dangerous
to use a dented or rusty cylinder.
WARNING: When the heater is used for emergency home heating use, never bring a refillable propane cylinder
indoors.
1) Open cylinder cover panel on left side of heater.
2) Connect 1lb. disposable cylinder to regulator by turning clockwise.
3) Before operation make sure control knob is on OFF position, and apply a mixture of liquid soap and water to all
joints. Make sure all the joints have been connected properly close cylinder access panel.
Attach to 1lb. cylinder regulator inlet. (see Figure 4)
NOTICE: This heater is intended for use as
supplemental heat. Use this heater along with
your primary heating system. Do not install
this heater as your primary heat source.
If you have a central heating system, you
may run system's circulating blower while
using heater. This will help circulate the
heat throughout the house. In the event of
a power outage, you can use this heater
as your primary heat source.
CAUTION: If you install the heater in a
home garage:
• Heater pilot and burner must be at least 18
in. above the floor.
• Place heater where moving vehicle will not
hit it.
WARNING: Never install the heater
• in a recreational vehicle
• where curtains, furniture, clothing, or other
flammable objects are less than 36 inches
from the front, top, or sides of the heater
• in high traffic areas
• in windy or drafty areas
Figure 4 Connecting propane cylinder