Tcp/Udp Switch; Reset; Configure Parameters By Usb; Gprs Setting - GPS Tracker GPS102 User Manual

If the local time zone is negative as "-8", then it should set as SMS:
"time zone123456 -8".

5.28 TCP/UDP switch

Command: "gprs+password,0,0" TCP with keep alive data, this is the default mode.
Command: "gprs+password,0,1" UDP with keep alive data
Command: "gprs+password,1,0" TCP without keep alive data
Command: "gprs+password,1,1" UDP without keep alive data

5.29 Reset

Send SMS "reset+password" to tracker, it will reply " reset ok", the GSM and GPS
module of the tracker will be reset.

5.30 Configure parameters by USB

Find the USB cable in the package to connect tracker with computer, open the memory
of the tracker, find and open the initial configuration file with notepad
operate according the instructions.
Note: Correct password is need every time you configure the tracker.

5.31 GPRS setting

User must send SMS via cell phone to set up IP, port and APN before starting GPRS.
5.31.1 Setting up APN
5.31.1.1 APN standards for Access Point Name and differs from country to country. For more
information about the local APN, inquire with your local GPRS network operator.
5.31.1.2 Text the tracker a SMS "APN+password + Space + your local APN" via a cell phone
16
,