On Board Receiver Programing - DTS 512 Installation Manual

Load setting
To adjust the load, turn the provided load pot very slowly to determine the load setting (Minimum-
anticlockwise & Maximum clockwise). The control card will beep as you turn the pot (1 - 5 beeps).

ON BOARD RECEIVER PROGRAMING

The onboard receiver is designed to work with Sentry rolling code transmitters.
PROGRAMMING A
TRANSMITTER FOR FULL
OPEN OPERATION –Bt Lrn
1. Push the Bt Lrn button, the
RX led will go on.
2. Push the required button on
the transmitter, the board
will give 2 beeps.
3. Repeat Step 1 and 2 for
additional transmitters. Up to
25 transmitters can be
programmed for this
operation.
The button used for Bt Lrn CANNOT be used for Pd Lrn and vice versa.
To erase a button from the receiver, in case of incorrect programming i.e. blue button should be for Bt Lrn
and not Pd Lrn.
Simply push and hold the Bt Lrn or the Pd Lrn for 5 seconds, the board will give 1 beep. Then push the button you
want to erase, the board will give 2 beeps as confirmation. That button is then erased and can be relearned into the
correct input
.
To master erase:
Push and hold the Bt Lrn or the Pd Lrn button, after 5 seconds the board with give 1 beeps. Keep holding for
another 5 seconds then the board will give 2 beeps. All transmitters will now be erased.
PROGRAMMING A
TRANSMITTER FOR PEDESTRIAN
OPERATION-Pd Lrn
1. Push the Pd Lrn button, the
RX led will go on.
2. Push the required button on
the transmitter, the board
will give 2 beeps.
3. Repeat Step 1 and 2 for
additional transmitters. Up to
5 transmitters can be
programmed for this
operation.
8