On Board Receiver Programming; To Individually Erase Transmitters; To Master Erase - DTS ECO 500 Installation Manual

Sliding gate motor

Hide thumbs

Table Of Contents

Table of Contents

The onboard receiver is designed to work with most rolling code transmitters.

PROGRAMMING A

TRANSMITTER (TX) FOR FULL

OPEN OPERATION – BT LRN

(Version 1.3)

Push the BT LRN button, the

RX led will go on.

Push the required button on the

transmitter, at arms length from

PCB once, the Rx led will flash.

Press the same button again, the

RX, Close & Open led will flash 3

times for a full Keelog transmitter

or twice for other transmitters.

Repeat Step 1 and 2 for additional

transmitters. Up to 31 transmitter

(Slots) signals can be

programmed as a joint

combination between BT LRN &

PD LRN.

The button used for BT LRN CANNOT be used for PD LRN and vice versa.

To individually erase transmitters:

To erase a button from the receiver, in case of incorrect programming i.e. blue button should be for BT LRN

and not PD LRN.

Simply push and hold the BT LRN button for 5 seconds, the RX led will light up and the Close & Open

led will flash once. Release the BT LRN button. Now push and release the TX button you want to erase, the RX, Close &

Open led will flash twice as confirmation. The TX is erased and can be re-learned into correct input.

To master erase:

Push and hold the BT LRN button, after 5 seconds the RX led will light up. Keep holding for another 5 - 10

seconds then the Close & Open will start flashing. Release BT LRN button. The RX led will flash 5 times as

indicating, all transmitters erased.

Note: When memory full & trying to program remote (TX) no.32, the Close & Open led will give a burst of

rapid flashes for 1.5 seconds after releasing the BT LRN button indicating, receiver (RX) is full.

The RX will abort programming automatically.

A TX must then be deleted before a next TX can be programmed to the RX.

If a transmitter is already programmed, the RX led will go off on the 1