On Board Receiver Programing - DTS 412 Installation Manual

Load setting
To adjust the load, turn the provided load pot very slowly to determine the load setting (Minimum-
a nticlockwise & Maximum clockwise). The control card will beep as you turn the pot (1 - 5 beeps).

ON BOARD RECEIVER PROGRAMING

The onboard receiver is designed to work with Sentry rolling code transmitters.
PROGRAMMING A
TRANSMITTER FOR FULL
OPEN OPERATION –Bt Lrn
1. Push the Bt Lrn button, the
RX led will go on.
2. Push the require
the transmitter, the board
will give 2 beeps.
3 . Repeat Step 1 and 2 for
additional transmitters. Up to
25 transmitters can
programmed for this
operation.
The button used fo Bt Lrn CANNOT be r
To erase a button from the receiver, in case of incorre
and not Pd Lrn.
Simply push and hold th e Bt Lrn or th
erase, the board will give 2 beeps as confirmation. That button is then erased and can be learned into the correct input.
To master e rase:
Push and hold the Bt Lrn or the Pd Lrn button, after 5 seconds the board with give 1 b
another 5 seconds then the board will give 2 beeps. All transmitters will now be erased.
PROGRAMMING A
TRANSMITTER FOR PEDESTRIAN
OPERATION-Pd Lrn
d button on
be
used for Pd rn and vice versa.
ct pro
e Pd Lrn for 5 seconds, the
8
1. Push the Pd Lrn button, the
RX led will go on.
2. Push the require d button on
the transmitter, the board
will give 2 beeps .
3 . Repeat Step 1 and 2 for
additional transmitters. Up to
5 transmitters can b e
programmed for this
operation.
L
gramming i.e. blue button
board will give 1 beep. Th
should b e for Bt Lrn
en push the button you want to
eeps. Keep holding for