Troubleshooting - DTS 512 Installation Manual

SYMPTOMS
When pressing the remote
transmitter the gate operator
will not respond at all
OR
PCB responds but gate will not
open
When pressing either the
transmitter or the PCB button
(Bt/SET), no movement or
opens a short distance only.

TROUBLESHOOTING

CAUSES
Transmitter battery flat.
Transmitter physically damaged.
Transmitter has not been
programmed into the receiver
memory.
Battery has reached its low level
(10/20 Volt) indicated by 3 beeps
/ 3 beeps.
Motor is in holiday lock-out,
indicated by 4 quick beeps.
Override door is open, indicated
by 3 short beeps.
PCB faulty, indicated by 1 long
and 1-5 short beeps.
Motor/Load Fuse blown,
indicated by the relays clicking
followed by 4 short beeps
Not picking up the encoder
reader, indicated by a short
movement followed by 4 short
beeps.
Motor overload, indicated by a
short movement followed by 4
short beeps and the St LED
flashing fast.
12
ACTION
Replace transmitter battery.
Check with supplier.
Follow the receiver setup
instructions.
Check the household main
supply, the transformer or PSU
and all related cabling.
Press and hold the pedestrian
remote for approximately 13
seconds. PCB will give 5 long
beeps to indicate holiday lock-out
is released.
Close override door.
Return PCB to supplier.
Replace the (12Volt) 25 Amp
Fuse, (24Volt) 10 Amp Fuse.
Fix encoder reader position to the
magnet on the motor.
Turn up the load on the load pot.
Remove any obstructions from
the rail.
Check weight and pulling force of
gate.