DTS Alt 600 Installation Manual

Sectional door operator

Advertisement

Dts Alt 600
SECTIONAL DOOR OPERATOR
INSTALLATION MANUAL
DTS SECURITY PRODUCTS CC
P.O.BOX 3399
EDENVALE
Base plate-mounting instructions
TELEPHONE: 086 1000 387
Alberton
Centurion
Edenvale
Pretoria
West Rand
www.dtssecurity.co.za
1
1610
011 907 8846
012 653 4434
011 524 0707
012 548 2336
011 760 6564

Advertisement

Table of Contents
loading

Summary of Contents for DTS Alt 600

  • Page 1 Dts Alt 600 SECTIONAL DOOR OPERATOR INSTALLATION MANUAL DTS SECURITY PRODUCTS CC P.O.BOX 3399 EDENVALE Base plate-mounting instructions 1610 TELEPHONE: 086 1000 387 Alberton 011 907 8846 Centurion 012 653 4434 Edenvale 011 524 0707 Pretoria 012 548 2336 West Rand 011 760 6564 www.dtssecurity.co.za...
  • Page 2: Table Of Contents

    INFORMATION FOR THE USER WARRANTY To the extent that they may be lawfully excluded, DTS Security Products hereby expressly excludes all conditions and warranties, statutory or otherwise, which may be implied by law as conditions or warranties of purchase of a DTS Alt 600 Garage Door Opener. DTS Security Products hereby...
  • Page 3: Contents

    1 Set Important Safety Warnings Unqualified personnel or those who do not know the The Alt 600 garage door opener described in this occupational health and safety standards applicable to manual is designed for the automation of residential automatic gates and doors category must under no...
  • Page 4: Operating Controls

    Operating Controls 1 SET Button (K1) Confirm set and Reversing sensitivity 2 CODE Button (K2) Transmitter code set 3 UP button (K3) Limit mode set. 4 DOWN button (K4) Limit mode set. Circuit Board Connectors 5 Coupling for connecting the backup battery. 6 Coupling for connecting the motor.
  • Page 5: Installation Instructions

    4) The door must be properly balanced and must be easily lowered and raised by hand. 5) Install a 220V, adequately protected 3-pin socket near where the Alt 600 opener is going to be installed Refer to Fig. 2 for recommended installation 5) Power Head...
  • Page 6 6mm-nut and then lock the brackets to the rail by tightening the inverted lock nuts (D). Fix the Alt 600 opener to the doorframe or to the ceiling with the correct fixing (Fig.5), maintaining a minimum gap of 30mm from the top panel’s maximum height (Fig.
  • Page 7 Important: Infra Red Beams must be fitted if autoclose is activated. the main supply. 3.10) When installing the Alt 600 opener, strictly follow the unit has mains voltage running through it Remember all the instructions given in the instruction manual. If (electrocution hazard, fire hazard).
  • Page 8: Description Of The Connections

    Only qualified, trained personnel may carry out the installation and subsequent maintenance. 24V DC 24V DC Whoever installs and uses the Alt 600 sectional door opener will be held responsible for any damage caused. Infra Red Beams (N/O) Infra Red Beams (N/O)
  • Page 9: Setting Of Open And Close Positions

    Setting Open and Close Function Modes Positions The unit has two selectable functioning modes, PHOTO 5.1) Press and hold SET(K1) until the LED displays the BEAM , AUTO CLOSE DOOR and LOCK DOOR. letter 1.It turns into opening position learn state. 7.1) PHOTO BEAM: 5.2) Now press UP(K3) again and hold, the door will travel to the open position, release the button when the...
  • Page 10: Self-Learning Transmitter

    It is important for the installer to show their clients correct automate sectional overhead doors up to a height of operational use of the Alt 600 including the use 2600mm and tilting overhead doors up to 2600mm. manual disengagement cord.
  • Page 11: Information For The User

    Important Information for the User Once the Alt 600 opener has been installed, the user must be informed about how it works and all the risks that can arise if it is used improperly. The user must avoid placing himself/herself in dangerous situations such as standing within the door’s operating range when it is...
  • Page 12: Warranty

    • All goods are warranted to be free from faulty components and manufacture. • Faulty goods will be repaired or replaced at the sole discretion of DTS Security Products, free of charge. • This warranty is subject to the goods being returned to the premises of DTS Security Products.

Table of Contents