Programing - DTS 512 Installation Manual

1 – Run Time Setup (This will automatically happen when triggered after total power up or
 Gate approximately 1metre open
 With all dipswitches OFF (excluding dipswitch 2 pending motor direction), press & release
Bt/SET button.
 Gate will close, open and close again and stop on close limit (Motor speed can be increased
during programming of open cycle by pushing and holding down the Bt/SET button). The
closing cycle of programming will automatically run at fast speed.
 Control card will beep to confirm end of run time setup.
NOTE: If gate opens first, dipswitch number 2 is wrongly selected.
2 – Auto close (Default 15 seconds) (Infra red beams must be fitted if auto close is activated).
 Switch Dipswitch 1 and 3 ON.
 Press & hold Bt/SET button
 PCB will Beep (1 Beep = 1 Sec)
 Release Bt/SET button at required auto close time.
 Switch Dipswitch 1 and 3 OFF.
 Switch Dipswitch 3 back ON to activate the auto close.
3 – Pedestrian Opening (Default 1 meter / 4 seconds auto close)
 Switch Dipswitch 1 and 4 ON.
 Gate should be in closed position.
 Press & Release Bt/SET Button.
 Gate will open.
 Press & release Bt/SET button to stop gate at required pedestrian opening distance.
 Press & Hold Bt/SET button to program auto close time required.
 Control card will Beep (1 Beep = 1 Sec)
 Release Bt/SET button at required pedestrian auto close time.
 Gate will close again.
 Switch Dipswitch 1 and 4 OFF.
To reset factory default, push and release Bt Lrn or Pd Lrn, then press and hold Bt/SET for
approximately 5 seconds, the PCB will give 2 short beeps as acknowledgement.

PROGRAMING

by following the steps below).
7