Pedal Assembly - LifeSpan RW1000 Owner's Manual

STEP 3:
ATTACH SEAT RAIL TO MAIN FRAME
a. Line the seat rail directly behind
the main frame and attach the
wire connectors coming from
the seat rail and main frame.
STEP 4:

PEDAL ASSEMBLY

a. Remove the an Allen screw and washer from one end of the pedal axle.
b. Push the end if the pedal axle through the top hole in the frame and
the only hole in the rail, with a spacer on one side. Add the spacer
and the pedal to the other side.
c. Using an Allen Wrench on each end of the axle, tighten the Allen
Screw with the washer that was removed earlier.
d. Insert locking pin in the lower hole of the main frame while lifting the
sliding rail up slightly near the pedal axle.
32
34
48
35
36
7
NOTE: Locking Pin will go through the lower hole
in the main frame and under the slide frame.
7
36
37
20
35
48