Advertisement
OPERATIONS
A Light switch on/off
B Fan motor on/off 1st level
C 2nd speed level
D 3rd speed level
E 4th speed level
F 10 minute timer
The touch control key allows the desired function to
be selected by touching the relevant key. The
luminous indicator (c) indicates shows fan speed
set. If the timer function has been activated the
corresponding light will flash.
If the touch control malfunctions, remove the grease
filters and press the red button inside the hood
twice. If the power supply to the hood is cut, 15
seconds are required for self diagnostics after the
power supply is restored.
Timer function: By pressing timer button the hood
will run for 10 minutes then shut down, this is ideal
for end of cooking to remove residual fumes.
Motor Level: Only run on a level which is enough
to draw away fumes and steam from cooking.
Beware when boiling water for a long time
condensation may form on the filter surface this is
normal due to steam hitting on a cold surface.
MAINTENANCE
To Replace lamp: Disconnect from power supply.
Remove the glass blocking ring (A) by levering with
a screw driver. This will also remove the glass (B).
Be careful not to drop the glass cover. Now you can
remove the lamp (C). Replace the lamp with the
same kind, being careful to avoid touching the new
lamp with bare hands. Replace the glass and ring.
Removal and cleaning of filters: Pull down the tab
in the middle of the filter. This will release the filter
from the front of the hood. Pull down and release
the filter from the tabs at the back of the hood. You
will now be able to remove filter completely. To
replace the filter, simply reverse these instructions.
Note: This appliance is fitted with a device so that
after 30 hours of working, the two central lights will
flash, indicating you should clean the filters. This
can be reset by pressing the timer button.
We would recommend the filters be cleaned
fortnightly when used in a "Normal" cooking
environment.
Advertisement
