Table of Contents
Advertisement
5. TC68S Installation
The TC68S is a plug-and-play (PnP) device, installation requires no wiring.
After connected the TC68S into the OBDII connector in the car, it will beep once, and all LEDs will begin to blink,
this indicated a successful installation.
Please ensure the device is firmly connected to avoid loosen later on.
5.1 Plug Car Connector Directly
5.2 Use the OBD Extender to Install (Optional)
Use the OBD Extender on the condition of narrow space for installation, in weak GPS signal, or for hidden
purpose.
When install the OBD Extender, please plug the male side to Car's OBDII connector, plug the female side to TC68S.
Affix two small suede Velcro to the labeled TC68S surface and the connected surface of the extender.
Copyright © 2014 Meitrack Group All rights reserved.
File Name
MEITRACK TC68S User Guide
Project
TC68S
Sub Project
User Guide
Revision
V1.2
Creator
Creation Date
Update Date
Page
Confidential
External Documentation
Renny Lee
2012-07-13
2014-02-26
15 of 16
-15-
Advertisement
Table of Contents
