Connectors; Connectors And Buttons - Axis A8004-VE User Manual

AXIS A8004-VE Network Video Door Station
Hardware Overview
2
Status LED
3
microSD/microSDHC/microSDXC slot supporting memory card up to 64 GB (card not included)
4
Protective rubber gasket
5
Back cover

Connectors

1
Network connector (PoE)
2
Relay connector
3
I/O connector
4
Audio connector
5
Power connector (DC IN)

Connectors and Buttons

For technical specifications, see page 72.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, time lapse recording
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for example:
PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes
active (shown under System Options > Ports & Devices).
1 2 3 4 5
8