Ending The Connection On A Line Key; Entering A Call On A Line (Three-Party Conference); Allowing Or Blocking A Party From Joining A Call; Allowing A Party To Join A Call - Siemens Hipath 4000 Operation Manual

Making Calls via Multiple Lines (Multi-Line)
Step by step
124

Ending the connection on a line key

n
Press the key shown. The LED goes out.
or
\
Replace the handset.
Entering a call on a line
(three-party conference)
Prerequisite: A call is in progress on one of the lines.
The line key LED lights up.
R
Press the line key. You and the parties already connect-
ed can hear the conference. All three parties can speak
with one another. The LED remains lit.
You cannot enter a conference, if the function "Pri-
vacy" is deactivated on your line.
If one of the three parties hangs up, the other two
remain connected.
If a connection remains between you, as the en-
tering party, and one of the other parties who pre-
viously occupied the line, consultation is no long-
er possible.
Allowing or blocking a party from join-
ing a call

Allowing a party to join a call

Your primary line may be configured so that other par-
ties may not join calls on that line when it is busy. In this
case, you can allow other parties to join a call. This au-
thorization applies to the current or the next call.
[
You are already conducting a call on one line.
or
^
Lift the handset.
With a programmed sensor key
S
Press the "Privacy" programmable sensor key.