Gamma 8800 Els Owner's Manual page 5

ASSEMBLY INSTRUCTIONS
"A"
Base Leg Assembly
The stringing machine uses a four leg base
design. The legs must be assembled to the
support post before use. Remove the lower
column support, the upper column support,
four (4) legs, four (4) socket head cap
screws and four (4) flat head cap screws
from the small shipping carton.
Base Leg Assembly (Cont.)
Align the holes in the leg flange with the
matching holes in the lower column support
post. Secure the leg with one FLAT HEAD
cap screw through the upper hole, and one
SOCKET HEAD cap screw through the bot-
tom hole. Repeat this procedure for the three
remaining legs.
Base Leg Assembly (Cont.)
To complete the base stand, screw the height adjust-
ment locking knob ("A") into the side of the support
column. The locking knob should not protrude beyond
the inside of the support column at this time.
4