Gamma 8800 Els Owner's Manual page 10

CONTROL PANEL FUNCTIONS AND
Keypad - Used to enter
tension settings
Tension Index Buttons - Changes
tension setting in +/- 1.0 or 0.1 Lb or Kg
increments. Holding the button down
will scroll the tension setting values up
or down. Tension settings entered with
the tension index buttons are placed
into temporary memory setting "0".
Clear Button - Clears display to enter a
new tension
Test Function - Performs internal
calibration check. Press and hold for 5
seconds until the winder reverses and
performs an internal diagnostic check,
such as the one performed at start-up.
Lbs/Kgs Button - Changes tension
display from Lbs to Kgs. Each press of
the button toggles back and forth
between Lbs and Kgs
Pre-Stretch Function - Pulls string
10% or 20% over the tension setting (up
to 90 lbs / 40.8 kgs), releases the string,
and repulls to the tension setting. Each
press of the button toggles between
10%, 20% or no pre-stretch.
FEATURES
Single Digit (0-4)
Memory LED Display
Release Button - Returns gripper to
starting position and releases tension
9
Three Digit (XX.X) Tension Settings or
String Length LED Display
Memory Button - Indexes from 4 preset
tension settings that can be stored in
memory. Settings are retained even if
machine is turned off. Each press of the
button indexes to the next memory setting.
Memory settings 1-4 must be entered using
the keypad followed by pressing the "ENT"
button.
Enter Button - Confirms tension setting
when entered on keypad (display flashes
when tensions are keyed in with the keypad
until this button is pressed)
Knot Function - Increases pulling tension
by 10% over the setting value (max 90 lbs /
40.8 kgs) for one pull. During pull the
Memory LED flashes to indicate that the
Knot function is enabled.
Speed Button - Changes pulling speed
of winder from Fast to Slow. Slow speed
is recommended for low stretch strings,
such as Kevlar. Each press of the
button toggles back and forth between
Fast and Slow speed.
String Length Meter Button - Enables
string length meter function. Each press
of the button toggles back and forth
between Meters and Feet measure-
ment. To switch back to tensioning
function, press the "Lbs/Kgs" button.