Control Panel; System Fans - Supero 2027R-WRF User Manual

SUPERSERVER 2027R-WRF USER'S MANUAL

Control Panel

Power Supply
COM1 Port
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
6-3

System Fans

Three heavy duty fans provide cooling for the chassis. These fans circulate air
through the chassis as a means of lowering the chassis internal temperature. The
SC213 fans are hot-swappable, enabling the fans to be replaced without powering
-down the system.
It is very important that the chassis top cover is properly installed and making a
good seal in order for the cooling air to circulate properly through the chassis and
cool the components. See Figure 6-2.System Fan Failure
Figure 6-1. Chassis: Front and Rear Views
Hot-Swap Drive Bays (16)
IPMI Port
USB Ports
PCI Expansion Slots (w/ Riser Cards)
Ethernet Ports
6-2
VGA Port