Installing Memory; Memory Support - Supero 2027R-WRF User Manual

SUPERSERVER
Installing the Heatsinks
We recommend the use of active type heatsinks (except for 1U systems). Use any
onboard fan header for the CPU's heatsink fan. To install the heatsink, please follow
the installation instructions that are included with your heatsink package.
Note: Make sure the heatsink is placed so that the fi ns of the heatsink are in the
direction of the airfl ow in your system.
5-5

Installing Memory

Caution! Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.

Memory Support

T h e X 9 D R W - i F s u p p o r t s u p t o 5 1 2 G B o f r e g i s t e r e d E C C
1 GB, 2 GB, 4 GB, 8 GB, 16 GB and 32 GB size SDRAM in sixteen (16) DIMM
slots of up to DDR3 1600/1333/1066/800 MHz speed. See the following table for
memory installation.
Memory speed support is dependent on the type of CPU used on the board.
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots, starting with
DIMM 1A. For best memory performance, please install memory modules
of the same type and same speed on the memory slots as indicated on the
tables below.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
2027R-WRF USER'S MANUAL
5-10