Slide the media device part of the way into the bay.
8.
Connect the four-pin power cable to the full-height or half-height drive.
9.
Connect the device cable to the device and the system board or to an expansion board as directed
10.
by the option documentation.
Slide the media drive fully into the bay until it is seated securely.
11.
Installing media devices with a media latch
You can install one full-height or up to two half-height removable media devices in the removable media
cage.
NOTE: The HP ProLiant ML150 Generation 2, the HP ProLiant ML110 Generation 3, and the HP ProLiant
ML110 Generation 4 Servers do not support full-height media devices.
NOTE: This process only represents one installation method. For specific instructions for installing the media
device into the server, refer to the installation sheet for your specific server.
Power down the server (on page 6).
1.
Hardware options installation 21