HP ML110 G2 User Manual page 17

ProLiant server
ProLiant ML110 G4
Server
ProLiant ML150 G3
Server
For optimal performance, avoid mixing SAS and SATA hard drives.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
IMPORTANT: If only one hard drive is installed, install it in the bay with the lowest device number. For
device numbering and drive installation guidelines, refer to "SAS and SATA hard drive guidelines (on page
42)."
IMPORTANT: Some ProLiant 100 Series servers support hot-plug functionality when an optional SAS or
SATA Smart Array controller is installed. For more information, see the installation sheet that ships with the
server.
NOTE: This process represents one hard drive installation method only. For specific instructions, see the
installation sheet that ships with the server.
To install the component:
Power down the server (on page 6).
1.
Open the bezel, if applicable.
2.
Remove the hard drive blank.
3.
SATA support SAS support
Embedded Optional HBA
Embedded Optional HBA
Maximum drives
4
6
Hardware options installation 17