Life Fitness X7 Assembly And User Instructions Manual page 36

S L A
TRIDE ENGTH DJUSTMENT
Turn the power off on the cross-trainer. Turn the power back on after 30 seconds and try the stride adjustment again.
S L
TRIDE ENGTH IS
Check to see if the Leg Sculptor mode is turned on. When on, the Icon Leg Sculptor key is illuminated. Leg Sculptor
automatically adjusts the stride every 2 minutes during a workout. To turn Leg Sculptor mode off press the Leg Sculptor
key.
S A
TRIDE DJUSTMENT
Some noise is normal. The sound of the motors will vary depending on the load.
S L F
TRIDE ENGTH EELS
Turn the unit off. Turn the unit on after 30 seconds and check to see if the stride length still feels longer on one side.
T B A
OTAL ODY RMS
Remove the moving arm pivot covers and check to make certain the bolt holding the total body arms in place is fully
tightened. If the total body arms still feel loose, you may need to disassemble the total body arms and make sure all of
the proper hardware from the assembly instructions was used.
A Z K
CTIVITY ONE EEPS
The activity zone is preset to turn the backlight off after 5 minutes in order to save power and LCD life. If you would like
the display to always be turned on sleep mode can be turned off in the settings menu.
W A Z
HEN CTIVITY ONE
The stride will always return to the home position of 18 inches (46 cm) when entering sleep mode. This is so the next
time you get on the cross-trainer it is at its lowest position. Sleep mode is a setting that turns the display backlight off to
save power and LCD life. It is preset to 5 minutes. If you would like the display to always be turned on sleep mode can
be turned off in the settings menu.
N W
OT ORKING
A C
UTOMATICALLY HANGING
S L
EEMS OUD
L O
ONGER ON NE
F L
EEL OOSE
T O
URNING FF
T O S
URNS FF THE TRIDE
S
IDE
C
HANGES
35