Table of Contents
Advertisement
Step 5
Assemble the Rocker Arms; Moving Arm Pivot Covers
Parts: Hardware Bag #3
Tools: 17mm Socket Wrench, Phillips Screwdriver
Slide one large flat washer (4) and one wave washer (5) onto the
user right pivot shaft (F). Slide the washers fully over the pivot shaft
until seated against the pre-installed stop ring (G).
Locate the user right rocker arm assembly (H) marked with a R. With
the top handgrip facing the front of the units slide the right rocker
arm assembly onto the user right pivot shaft until seated against the
washers.
Secure the rocker arm assembly to the pivot shaft using one flat
washer (6) and one 20mm long hex head bolt (7). Tighten the bolt
securely. Repeat the procedure for the left rocker arm assembly.
Attach the right side upper pivot covers (J) labeled with the letter "R"
over the upright shaft. Snap the covers together and use two 8mm long
black Phillips head screws (8) to attach the covers. Repeat for left side.
CAUTION: There is a different left and right cover.
14
(2, Wave Washers, 2 Large Flat Washers)
(2, Flat Washers)
(2, 20mm Long Hex Head Bolts)
(4, 8mm Long Black Phillips Head Screws)
Hide quick links:
Advertisement
Table of Contents
