Transferring Your Faxes Or Fax Journal Report; Document Jam - Brother FAX-2480C User Manual

Transferring your faxes or Fax
Journal report
If the LCD shows:
Change Unable XX, Clean Unable XX,
Init. Unable XX, Print Unable XX or
Scan Unable XX, we recommend
transferring your faxes to another fax
machine. (See Transferring faxes to another
fax machine on page 81.)
You can also transfer the Fax Journal report
to see if there are any faxes you need to
transfer. (See Transferring Fax Journal report
to another fax machine on page 81.)
Note
If there is an error message on the
machine's LCD, after the faxes have been
transferred, disconnect the machine from
the power source for several minutes, and
then reconnect it.
Transferring faxes to another fax
machine
If you have not set up your Station ID (see
Quick Setup Guide), you cannot enter fax
transfer mode.
a
Press Menu, 9, 0, 1.
b
Do one of the following:
If the LCD shows No Data, there are
no faxes left in the machine's
memory.
Press Stop/Exit.
If the LCD shows Enter Fax No.,
enter the fax number to which faxes
will be forwarded.
c
Press Mono Start.
Transferring Fax Journal report to
another fax machine
If you have not set up your Station ID, you
cannot enter fax transfer mode.
a
Press Menu 9, 0, 2.
Troubleshooting and Routine Maintenance
b
Enter the fax number to which Fax
Journal report will be forwarded.
B
c
Press Mono Start.

Document jam

Documents can jam if they are not inserted or
fed properly, or if they are too long. Follow the
steps below to clear a document jam.
Document is jammed in the top of the
ADF unit
a
Take out any paper from the ADF that is
not jammed.
b
Open the ADF cover.
c
Pull the jammed document up and to the
left.
B
d
Close the ADF cover.
e
Press Stop/Exit.
Note
To avoid document jams, close the ADF
cover properly by pressing it down in the
center.
B
B
B
81