Switch To Dual Power Meter Mode; Method 1] Switch By Pushing The Push Switch In The Right Transmitter - Pioneer SGY-PM910H2 Installation Manual

2.2

Switch to dual power meter mode

• Both the left and right sensors are required in this mode. Cyclocomputer SGX-CA500 is required when the sensor
changes to the pedaling monitor mode. It cannot be switched by using cyclocomputers from other manufacturers.
•The firmware version of SGX-CA500 needs to be 20150501.02.43 or higher. If it is of a different version, update the
firmware. Refer to the User's Guide (For WEB) of SGX-CA500 regarding how to update.
http://pioneer-cyclesports.com/us-en/support/products/
The mode can be switched in two ways.

[Method 1] Switch by pushing the push switch in the right transmitter

[Method 2] Switch the mode on SGX-CA500
2.2.1 [Method 1] Switch by pushing the push switch in the right transmitter
When using a Cyclocomputer from another manufacturer, switch with this method.
2.2.1.1 Loosen the screws on the right transmitter cover and remove the cover.
2.2.1.2 Replacing the batteries of theleft and right transmitters.
The operation is enabled for 5 minutes after the batteries are installed. Switch within 5 minutes. If more than 5 minutes
elapse, re-install the batteries of the left and right sensors.
2.2.1.3 Confirmation of the actual sensor mode.
When the batteries are installed, the LEDs on the left and right transmitters light as follows depending on the actual
sensor mode.
• When it is in pedaling monitor mode: The LEDs light green for 10 seconds
• When it is in dual power meter mode: The LEDs light orange for 10 seconds
• When it is in single power meter mode: The LEDs blink orange for 10 seconds
2.2.1.4 Switch the sensor mode.
• Before switching the mode, confirm that there is no other
pedaling monitor nearby. If this is not done at a sufficient
distance away from other sensors, the other sensors are likely to
malfunction.
8