Troubleshooting - Pioneer SGY-PM910H2 Installation Manual

8 Troubleshooting

Pedaling Monitor
Sensor
SGY-
PM910H2/HL/H
R
Question
A long push on the button
in the right transmitter
does not change the
Mode.
A six second push on the
button in the right
transmitter does not enter
Magnet Calibration Mode.
A short push on the
button in the right
transmitter does not
cause the LED to flash.
The LEDs do not light
during Magnet Detection.
Cannot switch from Single
Power Meter Mode to
Dual PowerMeter Mode.
Answer
The operation of the Mode Change
function is different in the SGY-
PM910H2. The same is true if the
firmware of the SGY-PM910H has
been updated.
* Please refer to the Dual <=>
Single Mode Switching Operation
* Please refer to the SGX-CA500
Mode Switching Operation
The operation of the Mode Change
function is different in the SGY-
PM910H2. The same is true if the
firmware of the SGY-PM910H has
been updated.
* Please refer to the Magnet
Calibration Function of the SGX-
CA500.
The operation of the Mode Change
function is different in the SGY-
PM910H2. The same is true if the
firmware of the SGY-PM910H has
been updated.
* Remove and replace the battery.
* Please refer to the Mode
Switching Function of the SGX-
CA500.
The SGY-PM910H does not have a
Magnet Detection Mode. Please use
the SGX-CA500 to update the
sensor firmware. Once the sensors
have been updated, functions such
as Mode Switching will operate
differently.
Please replace the battery.
Magnet Detection Mode only
operates for five minutes after the
battery has been inserted. If the
LEDs do not light, please try
removing and replacing the batteries.
Please check the position and
direction of the magnets and their
distance to the sensors.
Mode switching is only possible for
five minurtes after the batteries
have been inserted. Remove and
replace the batteries before pressing
the button .
22