4 Pairing with the Cyclocomputer
This section describes how to pair the installed pedaling monitor sensors on your bicycle to the SGX-CA500
Cyclocomputer.
If you are using this product with a Cyclocomputer from another manufacturer, the method of pairing is different. Refer to
the User's Manual of the Cyclocomputer you are using.
In the chapter" 2.1.7Add in the sensor list of SGX-CA500 ", already, if you are paired, the following process is not
required.
4.1
Check the sensor modes.
The actual sensor mode can be confirmed from the way the LEDs of the sensors light when the batteries are installed, or
from the way the LEDs light on switching to each mode.
4.2
Rotate the crank at least three times to start up both sensors.
4.3
Select the Sensor to connect on the Cycle Computer SGX
On the SGX-CA500, press the [Menu] button, then select [Sensors] – [Connect New] – [Device Type] –
[Pedaling Monitor R].。
16